When decorating the door, Van door seal is one of the indispensable important accessories. Van door seal is generally divided into three types: glass sealing tape, Van door seal and wool top. After installing Van door seal, the door will have good airtightness and water tightness.

The sealing strip is a product that seals a thing so that it is not easy to open, and has the functions of shock absorption, waterproof, sound insulation, heat insulation, dustproof, and fixation. Sealing strips are available in rubber, paper, metal, plastic and other materials.

The sealing strip market is mainly made of EPDM rubber, rubber and plastics, and can be divided into automobile sealing strips, mechanical sealing strips, and Van door seal according to their uses.

There are many types of sealing strip series, and the scope of application of different sealing strips is different. Therefore, when choosing Van door seal type, it must correspond to your own door, so as to make the door more tight. Pay attention to when choosing seals, choose non-toxic and tasteless environmental seals.

The tops are generally installed around doors and frame fans. The tops of good quality have a straight surface without bending, and the vertical hairs are smooth and even without lint. The specifications of the sealing strip should be matched. If it is too small, the sealing strip will fall off, which will affect the tightness of the glass and the fan body. Too large is difficult to assemble, and it will increase the resistance of doors and windows to move, causing inconvenience.

There are special sealing tape grooves on the door and the pressure strip. When installing Van door seal, carefully remove the debris in the groove to ensure that the gap on both sides is even. The installation part must be flat, not stretched, not crimped, and the joint should be less than 1mm.

When installing Van door seal on the door and frame fan, push the rubber strip slowly into the slot with a special roller in the correct position, and at the same time squeeze the rubber strip downward to make it fit into the slot. In order to prevent the elastic shrinkage of the rubber strip due to rolling, pay attention to the installation, first retract the two ends of the rubber strip to the middle, leave some length, and then cut the insertion slot.

How to install Van door seal on the door that has been completed? You can buy the kind of top that is directly glued. Use a tool shovel to cut a small opening of about 1cm on both sides of the top near the corner of the door. You can see that there is a groove, so just plug it in. This operation is a bit more troublesome.

Van door seal is generally used in doors. The Van door seal is installed through the layering and the inner fan to make the glass and the frame fan closer, forming a good waterproof and sealing effect. It also has functions such as dustproof, insectproof, and soundproof. Users must choose good quality Van door seal, so as to achieve the effects of high temperature resistance, anti-aging and long service life.