When installing the revolving door, stick a revolving door seal on the door, which can have the effect of heat preservation and sound insulation. So, how to affix the revolving door seal? Sticking the revolving door seal is divided into the following 5 steps, which must be installed strictly in order to ensure firmness. Let's take a look at the steps in detail:
1. Remove debris
In order to ensure that the revolving door seal can be pasted more firmly and prevent it from falling off, the sundries in the door slot must be cleaned before pasting. For example: some mortar, wood blocks and other sundries, these sundries are accumulated in the tank, which will affect the installation of the revolving door seal. Secondly, it is also necessary to ensure that the gap on both sides of the door is even. If the gap is different in size, it must be dealt with in time to prevent the sealing strip from shifting and the installation is not firm.
2. Install the sealing strip
After cleaning, you can start to paste the revolving door seal. You must first measure the length and width of the door, and then cut the revolving door seal according to its size. When installing, just tear off the tape on the back, align it with the position to be pasted, and stick it directly. Pay attention when cutting the revolving door seal, try to cut it larger first, otherwise if it is too small after installation, it will affect the paste effect. The surface of the revolving door seal should be straightened and in close contact with the door groove, so as to ensure that the surrounding force is even.

3. Glue injection
After the revolving door seal is pasted, in order to ensure that it can be firmly pasted, you can also fill the place where it is pasted with sealant. You can use a small wooden stick to squeeze the sealing strip, leaving a gap for glue injection, and the gap for glue injection should not be less than 5mm. If it is too shallow, the glue will overflow soon, affecting its firmness. And before the glue is cured, the door cannot be pushed and pulled to prevent the glue from falling.
4. Fixed
After injecting glue to the sealing strip, press it firmly with your hands so that the revolving door seal can be tightly attached to the door, so that the revolving door seal can be attached very firmly.
5. Inspection
Finally, after finishing everything, carefully check whether it is firmly pasted so as not to fall off.