How much do you know about the method of removing the bead outside the car window? Follow the editor of Car door glass weatherstrip For sale for a simple understanding!
1. We need to prepare the tools needed to dismantle the entire outer layer of the car window glass, a small flat-head screwdriver, a large flat-head screwdriver, and a t-20 spline, and then let's start the operation. !
2. Open the door of the car. On the side of the door, we will find a small black cover. This small black cover plays a decorative role. It needs to be disassembled to find the screws that fix the bead outside the window. Take out the small black cover. Use a flat-head screwdriver to pry off the small black cover. Be careful when you pry it lightly, don't scratch the paint surface of the door panel, and put the small black cover away.
3. After the small black cover is disassembled, we will find the screw that fixes the outside pressure strip of the car window. Take out the t-20 spline and use the t-20 spline to disassemble this screw. The disassembled screws need Put it away for use during installation, and this kind of screw is difficult to buy, so please pay attention to this.
4. Disassembly of the pressure strip outside the car window. Take out the large flat-head screwdriver, and use the large flat-head screwdriver to gently pry from the edge of the pressure strip outside the window to loosen the pressure strip outside the window, so that we can dismantle it. This step has relatively high technical requirements, mainly not to open the door. The paint surface is scratched, which affects the appearance. When you do this step, you must be gentle and careful.

5. Next, we use our fingers to hold the outside pressure strip of the car window, and then gently push it upwards. Slowly, the outside pressure strip of the car window will separate from the edge of the car door. Pay attention to it slowly, little by little Break the ground up and use too much force. It is easy to deform the outer bead of the car window, so that the outer bead of the entire car window cannot be used. You need to pay attention to this point.
6. When the pressure strip outside the car window is about to be removed, it must be lighter and slower to avoid damaging the door paint or the sealing strip. This requires everyone to be careful and patient. To achieve these two points, I believe It must be dismantled smoothly.
7. The dismantled car window outside bead must be placed in a soft place, and it can also be placed on the rear seat in the car, so as to protect the bright side of the car window from being scratched, and the details should be done Good, but also for the beauty of our vehicles.
The above is the editor of Car door glass weatherstrip For sale: about the method of removing the bead outside the car window.